Mobotix D14D - Adjusting the Lens

70/126
D14D Camera Manual: Mounting

www.mobotix.com • sales@mobotix.com
2.6
Make sure that you see the live image of the camera on the monitor of your computer or
laptop. Now adjust the lenses one by one until you see the desired image area on your
monitor:
Remove the
• camera dome using a lint-free cotton cloth.
• Release the  of the lens, adjust the  and
tighten the lock ring again. 


• using a soft cotton cloth.
Notes
The  provides a visual aid when setting the image sharpness of
a MOBOTIX camera lens (see Section 4.3.3
Image and Audio Settings, Quick
Controls
in the Software Manual ).

Due to the lens eect of the dome, the focus of the 135 mm
telephoto lens shifts slightly once the dome has been mounted. Before
mounting the dome, the telephoto lens should be rotated by about 90° in a
 (against the direction in which the lens is screwed).
Make sure that you check the focus of the live image with the dome installed
and readjust the lens, if required.
We do not recommend (even) aligning the telephoto lens horizontally due
to the image distortions that occur in the top part of the dome for technical
reasons.
L
o
c

r
i
n
g
Lock ring secures lenses
against vibrations
90°