Mobotix D14D - Replacing the Microsd Card

58/126
D14D Camera Manual: Mounting

www.mobotix.com • sales@mobotix.com
2.3.6
If the supplied 4-GB MicroSD card is to be replaced (for example, with a 64-GB MicroSD
card), it is best to do so  the camera is installed. 

 1. : Remove the outer shell using
the supplied custom tool. Insert the tip of the custom
tool into the three small holes of the shell, one by one.
Lift the outer shell to loosen it from the fixtures.
Remove cable cover
2. : Remove the two M4x25 Allen
screws from the cable cover using the 3-mm Allen
wrench.
Remove cable cover
3. : If you are unable to do so by
hand, press a suitable tool (screwdriver) into the
notches provided for this purpose (red arrows).
Carefully lift the cover upwards in the direction of
the dome.
4.    : Carefully press the
MicroSD card into the mount until you hear a .
The card now protrudes from its seat and can be
removed (tweezers may be used to facilitate
removal).
Use the supplied
custom tool
Push-push:
Push the MicroSD card
in, then pull it out