Dansensor A/S COPYRIGHT © P/N 330654-E 01/2018
Lippke 4000/4500 EN User Guide 9
Safety Instructions
Personnel operating and maintaining the device must be familiar with all aspects of its operation and be
proficient in maintenance.
Such personnel should review the following precautions to promote safety awareness.
General
• Always refer to the manual before operating or maintaining the equipment.
• Observe all WARNINGS, CAUTIONS and NOTES.
• Do not open the device. In case of technical problems please contact your service provider.
• Do not cover the machine with a cloth or piece of plastic to protect it from dust, as this prevents free
air circulation around the machine and might lead to overheating.
• Do not expose the equipment to heavy moisture or heat and keep it away from direct sunlight.
• Never short circuit or remove safety devices.
Installation
• To ensure the best installation with the least technical problems, please install equipment as described
in this manual.
• Only operate the system with the mains voltage indicated on the nameplate.
• Never install the equipment in explosive environments.
• Always use correct fittings when connecting compressed air to the device.
• Provide adequate space around the equipment for proper ventilation.
• The units are Class 1 appliances and must
be connected to an earthed mains connection.
• It is the responsibility of the owner and operator(s) of the equipment, that the installation is made in
accordance with local rules and regulations.
• The manufacturer cannot be held responsible for any damage caused by incorrect installation of this
equipment.
Operation and Maintenance
• Be sure to disconnect compressed air supply hoses and electrical power cables before performing any
cleaning or maintenance.
• All panels and protective guards must be in place before operating the equipment.
• When operating or maintaining the equipment always obey the relevant rules and regulations for
workers safety.
• Repair or replace damaged power cords immediately.
• Never block gas outlets.
To Next Page
Loading...