Dansensor A/S COPYRIGHT © P/N 330654-E 01/2018
Lippke 4000/4500 EN User Guide 59
Ventilate Select how to ventilate the package after a test: auto, manual or Off.
NOTE! If set to “auto” the package will be ventilated through
the device. In this case you must make sure that the package
does not contain a product that can be pulled back through the
device.
Ext. Inputs It is possible to start and stop the device from an external source.
To do this use the 15-pin Sub-D “Accessory Port” connector on the back.
See "Connection of external control device" on page 54 for details.
Pressure Cal. Only for Service Technicians - do not use!
Data Output:
Test Number Output With every printout an incremental test number is printed. The value can not
be changed.
Output to Printer or PC
Printouts Set number of printouts for each test
Baud Rate Select transfer speed: 9600 or 19200
Cutting Signal Signal in HEX to activate the cutting on the printer
(See also printer manual)
Line Feed Number of line feeds at the end of a page
Form Feed Number of form feeds at the end of a page
Data Transmission
User Database Send/receive User data (User administration)
Parameter DB Send/receive the test database
System config. Send the serial number, hour counter and the calibration factors to a PC or
printer.
User Administration
See "User administration" on page 60 for details
Language
Select the instrument interface language:
- English
-German
-French
-Spanish
To Next Page
Loading...
