Appliances
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
DIPLOMAT 4•117
Hook Up LP-Gas Supply:
• Pull hose from storage compartment.
• Make sure grill LP-Gas control valve is in CLOSED position.
• Snap female disconnect from hose end onto male fitting on grill.
This is done by drawing back the spring loaded lock ring, on
female disconnect, then pushing disconnect over the mating male
fitting until the ring snaps back into place.
• After disconnect is properly attached, OPEN valve located on
female disconnect.
• Check for gas leaks on hose or grill, use a solution of 1 part liquid
dish detergent to 10 parts water. Agitiate solution until bubbles form,
then apply to all fittings and the inlet to grill control valve. If a leak is
detected, turn gas off at main LP tank and contact a qualified service
center for repairs.
Lighting the Grill:
• Raise the lid of grill before lighting.
• Locate lighting hole on the bottom of grill. Hold a lighted hand
held trigger type butane lighter under the lighting hole and turn
burner gas valve to HI position. Burner should light within 5
seconds. Flame will be visible through the narrow slot in flame
spreader. Adjust burner to desired temperature.
WARNING: If burner does not light, turn burner
control off. Wait five (5) minutes for gas to clear
before trying to light burner again.
WARNING: Keep grill area clear and free from
combustible material, gasoline and other flammable
vapors and liquids. Do not obstruct the flow of com-
bustion and ventilator air around grill.
OM020157.eps
OM020155.eps
om020156.EPS
To Next Page
Loading...
