Electrical Systems - House
---------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
DIPLOMAT
8•210
NOTE: An appliance or load may have a short if it causes a
circuit breaker to trip after reconnection. DO NOT continue
to reset breaker. Have a problem corrected before resuming
operation.
If use of the generator is infrequent, “exercise” the generator once a month
by operating it at approximately half the maximum rated output for two hours.
This “exercise” will help promote better starting, more reliable operation and
longer engine life. This procedure drives off moisture, lubricates the internal
engine parts and replaces the old stale fuel with a fresh supply. It also promotes
removing the oxides from the electrical switches and contacts.
NOTE: Avoid short run periods of the generator set. Run the
generator set under a load for a minimum of one-half hour.
Use the inverter when shore power is not
available and the generator is not going to be
used as the secondary AC power source option.
This will supply silent AC power to most recepta-
cles, the television and microwave. It is important
to remember that use of the inverter will greatly
increase house battery power consumption. Turn
off the inverter when not in use to conserve house
battery power. One circuit breaker is used to pro-
tect the microwave and the other one protects the
refrigerator and bathroom (GFI).
NOTE: The switch on the inverter
unit is to remain in the ON position.
To turn inverter on:
• At the inverter turn ON the inverter/converter power switch. The
INVERT push-button switch is located on the front of the unit and
has two functions:
• Turn the inverter ON.OFF and reset after a fault condition. Pressing
the INVERT switch turns the inverter ON. The green INVERT LED
will be ON when the inverter is inverting. When the inverter is ON,
pressing the INVERT switch turns the inverter off.
• At the remote control panel in the hall area, press the INVERT
switch on the remote panel.
INVERTER/CONVERTER
OM060157.eps
To Next Page
Loading...
