The sofa will convert easily into a bed. Clear the area of obstruction. The
sofa comes equipped with safety belts and these should be used if occupied
during travel.
• Unlock latch at bottom center of sofa and pull bed extension frame out
all the way.
• Lift bed extension cushion up and pull out all the way to lock into
extension frame.
• Push switch on sofa arm to position back and bottom cushions flat
against the bed extension cushion.
• Push switch on sofa arm so that back and bottom cushions are in the
sofa position.
• Push in and down on the bed extension cushion to place cushion in
stored position on frame.
• Push bed extension frame under sofa into locked position.
• Position the seat belts for use.
The booth dinette easily converts into a bed:
• Lift seat cushions to an angled vertical position.
• With a firm grip, lift front edge of the table approximately six inches and
push table leg lock to side.
• Swing the table leg up and lock into a horizontal position.
• Continue lifting table until table stays are clear of retainers. Pull
outward and lower table down.
• Use both seat cushions and one back cushion for a mattress. Leave one
back cushion in a vertical position.
WARNING: Do not occupy the booth dinette, if not equipped
with safety belts, or the dining chairs while the motorhome is
in motion. To avoid personal injury to occupants in case of a
crash or sudden stop, chairs must be stored in an enclosed
area or secured with tie down straps while the motorhome is
in motion.
Equipment
------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
DIPLOMAT 5•165
ELECTRIC SOFA
BED CONVERSION
(Optional)
Sofa to Sleeper
Sleeper to Sofa
DINETTE BED
CONVERSION
(Optional)
To Next Page
Loading...
