53 | P a g e
The new filter will side in and rest behind the grill. Once installed close the filter hinge and re-install the
two thumb screws on each end. The filter change interval will vary depending on cleanliness of the
incoming air. The best practice is to change filters quarterly. Please see section 10.1.2 for replacement
filters.
CAUTION clogged or neglected in-duct filters will negatively affect performance of the
ventilation and does require an established interval for replacement.
7.1.5 Resetting/Leveling the Elevation System
Should your station become unlevel for any reason follow the steps below to reset the elevation system. An unlevel
elevation system can cause objects to roll off the worksurface or cause fluids to not drain properly.
• Press and hold both the up/down arrows at the same time.
To Next Page
Loading...
