57 | P a g e
• Use 120 grit emery cloth or paper and firm pressure to sand the scratch.
• Sanding must always go in the direction of the grain. Sand in a perfectly straight line, avoiding the natural
tendency to sand in an arc. Sand the surface until the scratch is gone.
• Polish using a very fine grade of 3M scotch-brite pads. Use the same motions as with sanding. Polish the surface
until the original finish is restored.
7.2.6 Fingerprints and solvent cleaning
The most common surface contaminants that occur from normal use are fingerprints and mild stains. These usually
affect only appearance and do not affect corrosion resistance. They can easily be removed by a variety of simple
cleaning methods.
• Fingerprints can be removed with a common glass cleaner or by gently rubbing with a paste of soda ash (sodium
carbonate) and water which would be applied with a soft cloth. It is best to follow with a warm water rinse.
7.3 Mopec Service
PLEASE have the following information available BEFORE you call from your station ID tag or original order or quote.
Reference the ID tag located near the Power Switch under the GFCI outlet.
Product Model Number: Example: MB1060
Product Serial Number: MB1060-0-140203-001
Call 1-800-362-8491 and follow the prompts. Or email us at customerservice@mopec.com
To Next Page
Loading...
