Morgana Digifold Pro CB - ENGINEERING SET-UP & CALIBRATION TECHNIQUES; Pre-Power Setup Procedure; Powered Setup Procedure

Page5SYSTEM
PAGE
…..OpticalSensors…….………………………………………….........
.............................................CleaningSensors-Creaser.......................................29
.............................................ChangingSensors-LeadingEdge............................30
.............................................ChangingSensors-Crunch.......................................30
.............................................ChangingSensors-FolderUnitClip1&2..................31
…...Removing/ReplacingFoldKnifeAssembly……………….……
.............................................UpperFoldKnife.........................................................32
.............................................BottomFoldKnife.......................................................32
…..MainFoldRollersRemoval…………………………................
.............................................RemovalThirdFoldRoller...........................................33
.............................................RemovalSecond/FirstFoldRoller...............................34
.............................................MainFoldRollers-Replacement...............................35
…..PerforatorUnit…….…………………………………………..........
.............................................ReplacingtheGasStrut.............................................36
----------------------------------------
Pre-PowerSetupProcedureFlowChart.............................38
.................LoadingTableAlignment.....................................................39/40
.................DynacreaseAlignment........................................................42/44
.................BeltTension........................................................................45
................CreasingBladeInstallation...................................................48
................InputRollerGearMesh.........................................................50
................UpperInputRoller-SettingtheParalllelism&Pressure......51
................FoldRollers-SettingtheParallelism&Pressure.................54
................PerforatorAssembly.............................................................56
................SettingTheFoldKnives........................................................58
..............AdjustingTheTopCoverSafetySwitch................................60
----------------------------------------
PoweredSetupProcedureFlowChart.................................61
..............ControlSystemSetup...........................................................62
…..........FoldRollerGapPotentiometers...………..............................63
…..........DynacreaseTiltPotentiometer..............................................64
……......SettingTheVacuumDrumandPapergate...………….......…64
SectionH
SectionJ
SectionK
SectionL
Pre-PowerSetupProcedure
Section1
Section2
Section3
Section4
Section5
Section6
Section7
Section8
Section9
Section10
PoweredSetupProcedure
Section11
Section12
Section13
Section14
ENGINEERINGSET-UP&CALIBRATIONTECHNIQUES
DigifoldPro