Morgana Digifold Pro CB - Calibration; 21. Delivery Roller; 22. Crease Positions - Set by Position; 23. Fold Positions - Set by Position

Page80
Calibration
Thisisthefinalcalibrationprocedureandcloselyfollowsthe'Calibration'flowchart.You
musthavecompletedallprevioussetupproceduresleadinguptothisfinalcalibration.
Ifadditionalinformationisrequiredforsettingupthevariouscreaseandfoldvariations,
pleaserefertotheoperatorsmanual.
Thedeliveryrollerneedstobecalibratedtoensurethecorrectpositionsareachieved
duringautomaticsetup.Inthe'Tools'menuadjustthe'DeliveryRollerTrim'untiltheupper
stoppingpositioniswithin3mmoftheperforatorcover.
Usingtheteststock,setup'CreaseOnly'at50and370,Checkthecreasepositionsand
usingthe'Stretch'and'LeadEdge'settingsinthe'Tools'menu,adjustthecreasepositions
untiltheyarecorrect.
-AlwaysSettheStretchfirsti.e.320mmbetweencreases.
23.1.Usingtheteststock,setup'foldonly'(ieturnoffcreasing)at100and250.
Checkthefoldpositionsandadjustifnecessaryusingthe'Fold1'
and'Fold2'adjustmentsinthe'Tools’Menu.
DonotusedamagedTestStock.
21.
22.
23.
DeliveryRoller
CreasePositions-SetbyPosition.
NOTE
FoldPositions-SetbyPosition.
WARNING.
CREASING/FOLDING