1.2
Related Documents and Information
For subjects related to your V700 body-worn camera that are not covered by the V700 Body-Worn
Camera User Guide, see the following documents:
• M500 In-Car Video System User Guide
• V300 Body-Worn Camera User Guide
• Transfer Station II Quick Start User Guide
• 4RE
®
In-Car Video User Guide
1.3
Prerequisites and Requirements
Ensure that you complete the prerequisites and meet the requirements.
Prerequisites
• The V700 requires a second-generation transfer station, WiFi Base, and/or USB Base
NOTE: You can dock either the stand-alone battery in the bases or the camera and battery
together. Docking both allows you to charge and upload at the same time. However, docking
a spare battery allows you to have a second battery available when needed. The camera
and battery only dock in one direction.
• Transfer Station II provisions the V700 to your agency evidence management system
• USB upload requires that your Primary Domain Name is set in your agency evidence management
system and that you have an IP address set for the DNS Server Primary field
For more information, see USB Dock and Upload on page 50.
Reserved IP Addresses
V700 components require the following reserved IP addresses:
• 192.168.99.x (USB and WiFi Base)
• 192.168.98.x (SmartControl)
• 192.168.97.x (reserved for future use)
If you assign your in-car network any of these IP address ranges, you may have communication
issues.
Warning
WARNING: If the V700 is lost or there is any suspicion that it was tampered with, do not
connect the camera to your network or place it in a USB Base or WiFi Base. You should return
the camera to Motorola Solutions to download the evidence and perform a factory reset; this
ensures no damage is caused to the servers by malicious code placed on the camera.
MN009878A01-B
Chapter 1 : Introduction
17
To Next Page
Loading...
