acknowledge it and reoccurs every one percent drop. The warning stops when the battery is charged
or dead. No notification appears for a normal battery level.
For more information on the different sensor battery levels, see Sensor Battery Levels on page 47.
2.13.3
Sensor Battery Levels
Table 7: Sensor Battery Levels
Percentage Status Notifications
Above 25%
Normal
No notifications are sent.
25-21%
Low
Notification is sent on the UI with vibe or tone feedback or both,
depending on your configuration. It times out after five seconds
or when you acknowledge it with a button press. It does not
persist throughout the recording.
Notifications are sent every 1% at 25% and below.
At or below
20%
Critical
A critical battery notification that persists on the screen until you
press a button to acknowledge it. It also clears if a recording is
started until the recording and tagging are complete.
2.14
V700 Docking Overview
You can dock the V700 in the following bases:
• WiFi Base (Dock the V700 in a WiFi Base on page 48)
• Transfer Station II (Dock the V700 in a Transfer Station II on page 49)
• USB Base (USB Dock and Upload on page 50)
While docked, you can do the following:
• Charge the battery
• Upgrade firmware for the V700 from Transfer Station II and WiFi Base
• Upload recorded events from Transfer Station II
• Upload recorded events from the WiFi Base
• Upload recorded events from the USB Base
• Define a Record-After-the-Fact
®
(RATF) event
• Request a state capture from Transfer Station II for troubleshooting
NOTE: The camera and battery can only dock in one direction in the bases. Do not remove the
camera from the battery while it is charging. You can damage data or evidence on the camera.
The camera can be paired with the WiFi Base to associate with other V300 or V700 cameras and the
in-car video system to form a recording group (V700 in a Recording Group on page 37).
MN009878A01-B
Chapter 2 : V700 During a Shift
47
To Next Page
Loading...
