Motorola solutions V700 - Camera Charging Display; Camera Shutting down Due to Low Battery; Assigning a Configuration and Checking out; Associate a V700 with a Recording Group

Charging a battery in a vehicle that is not running can impact the vehicle battery. For the best battery
life and fastest charging times, you should charge the V700 in a cool environment.
IMPORTANT: If the ambient temperature gets too hot (40° C / 104° F), the battery may stop
charging. You must not leave the camera and battery in a hot car.
2.4.1
Camera Charging Display
While the V700 is charging, the event count remains on the screen.
When the camera is fully charged:
• The display shows CHARGE COMPLETE once, then returns to the Home screen
• The display shows 100% and a fully-filled Battery Charge icon on the Home screen
• The green LED displays a steady light
• Two tones sound
2.4.2
Camera Shutting Down Due to Low Battery
If a low battery error is issued, you should shut down the V700; this can leave two to four minutes of
run time before the camera runs out of power. You should switch to your charged backup battery.
2.5
Assigning a Configuration and Checking Out
Depending on how your agency assigns its cameras, you may need to configure and assign the
camera each time it is checked out.
NOTE: Before using the camera for the first time, fully charge the battery and assign a
configuration and officer to the camera. For more information about configuring your V700,
see V700 Configuration on page 53.
Procedure:
1 Dock the camera in the Transfer Station II connected to a computer with access to your agency
evidence management system.
2 Using your agency evidence management system, perform the following actions:
a Create and assign a configuration to the docked camera.
b Assign an officer to the docked camera.
IMPORTANT: If you have the battery with the attached camera docked, ensure that you
remove them together. Undocking one without the other can damage your data.
The camera vibrates when the update completes. If automatic configuration updates are enabled, the
V700 checks every 10 minutes to see if there is a change to the configuration.
2.6
Associate a V700 with a Recording Group
When you dock your V700 in a WiFi Base, the camera pairs with the base. This pairing allows the
camera to associate with the local recording group that includes other V700 or V300 cameras and,
MN009878A01-B
Chapter 2 : V700 During a Shift
30