Motorola solutions V700 - Stopping a Recorded Event Manually; Categorizing a Recorded Event

The top and front LEDs illuminate in red to indicate that the camera is actively recording. If the camera
is in Covert Mode, the top and front LEDs remain off even while the camera is actively recording.
As the recorded event continues, the display shows the storage indicators updating.
2.7.2
Stopping a Recorded Event Manually
You can manually stop a recorded event on the V700.
Procedure:
1 On the front of the camera, press the Record Start/Stop button.
2 Press the Record Start/Stop button again within five seconds.
NOTE: If the record stop confirmation is not enabled, you only need to press the record
button once to stop an event.
IMPORTANT: The V700 can be configured in your agency evidence management
system to not allow an event to stop manually. If you cannot stop the event manually
when you press the Record button, two low tones sound with vibration, depending on
your alert notification selections, and the display reads IGNORED for three seconds.
NOTE: Your agency configures your Record Start/Stop options in your agency evidence
management system. See Start and Stop Recorded Events on page 31 for the available
configurations.
On the camera, the display and front red LED turn off and the top LED turns green.
After a recorded event stops, if your configuration requires event categorization, the event
categorization sequence starts. For more information, see Categorizing a Recorded Event on page
32.
2.7.3
Categorizing a Recorded Event
Event categorization is set up in the V700 configuration of your agency evidence management system,
in which your agency sets the categories.
Procedure:
1 Stop the event manually or allow the camera to stop it automatically.
If the camera is not in Covert Mode, the Display Backlight turns on and the display shows the
default category on the top.
If tagging is not required, the prompt times-out after 30 seconds.
2 Press and release the Display Backlight button as many times as needed to move through the
list of event categories.
3 Press the top Function button when the event category you want to select appears on the
display.
MN009878A01-B
Chapter 2 : V700 During a Shift
32