Motorola solutions V700 - Muting the V700; Continuous Mute; Enabling Continuous Mute; Disabling Continuous Mute

2.8
Muting the V700
A configuration setting in your agency evidence management system controls whether you can mute
your V700 during a recorded event.
NOTE: Depending on your agency preference, you can have either Continuous Mute
(Continuous Mute on page 35) or Momentary Mute (Muting Audio Momentarily on page 35).
2.8.1
Continuous Mute
You can mute your V700 during an event by pressing and holding the Function button.
The camera can be configured to alert you while it is muted. Your administrator configures the alert
type under officer device preferences.
2.8.1.1
Enabling Continuous Mute
Procedure:
If enabled by your administrator, you can press and hold the Function button for two seconds to
mute the microphone during an active recorded event.
While muted, the camera displays MUTE ON.
2.8.1.2
Disabling Continuous Mute
Procedure:
1 To disable continuous mute, press and hold the Function button for two seconds.
The camera displays MUTE OFF.
NOTE: The camera can be configured to unmute itself. Your administrator configures a
maximum duration for muting. When this configuration is enabled by your administrator,
the camera unmutes itself after the configured number of minutes. The camera creates a
beep/vibe notification 5 seconds before it unmutes and again when the device unmutes
itself.
2.8.2
Muting Audio Momentarily
Procedure:
1 Press and hold the Display Backlight button to briefly mute the audio.
NOTE: Your administrator must enable the configuration setting to allow muting.
MN009878A01-B
Chapter 2 : V700 During a Shift
35