Motorola solutions V700 - Re-Pair V700 and APX Radio Connection; Out-Of-Range; No Connection in the Field; Holster Aware

2.12.3.2
Re-pair V700 and APX Radio Connection
If you need to pair your V700 to the APX Radio again, before pressing both buttons on the V700, you
must go into the APX Radio settings and delete the V700 from the radio; this ensures a successful
connection between the devices.
2.12.3.3
Out-of-Range
If a camera moves out-of-range from the radio, the radio tries to reconnect for approximately eight
minutes. If the camera stays out-of-range longer than eight minutes, you have to reconnect the two
manually by using the radio screen.
2.12.3.4
No Connection in the Field
If a radio triggers an emergency and the V700 is not paired with the radio, you need to go through
the pairing process to connect them. See Pairing the APX Radio with V700 on page 43 for more
information.
Once a V700 is paired with an APX Radio, when either the radio or the camera reboots, the rebooted
device tries to re-establish the connection. If the camera is not in range at the time of this re-connection
attempt, you need to go into the APX Radio menu and manually start the connection from there.
2.13
Holster Aware
Yardarm
®
Holster Aware detects when a weapon is removed from or inserted into a holster. It
wirelessly activates a recording on the V700 when a holster sensor is paired with the V700.
You can have a holster sensor and APX Radio connected at the same time.
You can have a holster sensor, APX Radio, and SmartControl smart phone app, connected at the
same time.
After you check out a camera and pair with a holster, the pairing information is assigned to your ID.
It is stored in the officer preferences. At the end of the shift it is uploaded to your agency evidence
management system to be used on the next shift. The next time you checkout, your pairing information
is sent to the camera as part of checkout.
2.13.1
Connecting Yardarm Holster Aware
Procedure:
1 Connect the power supply to the sensor to pair the sensor with a V700.
You have one minute to pair the sensor and camera.
2 Press the Function and Display Backlight buttons for five seconds to enter the pairing menu.
The discover process cycles through SmartControl, APX Radio, then Firearm.
The discover process cycles through APX Radio then Firearm.
MN009878A01-B
Chapter 2 : V700 During a Shift
45