Table 21: SmartControl Services Enablement Items
Item Description
1 SmartControl wants to turn on WiFi. You must select ALLOW to enable the service.
2 SmartControl wants to turn on Bluetooth. You must select ALLOW to enable this
service.
3 Allow SmartControl to access this device's location. You must select ALLOW
to enable this service.
If you decline, the location access a second time. Selecting Try Again does not work.
You have to reset location access outside the app in your device.
4 To continue turn on device location, which uses Google Location service, you must
select OK.
If you encounter SmartControl connection issues on your Android device, see Troubleshooting Android
Connection Setting Issues on page 76.
iOS
For iOS, it requires you to enable only Wi-Fi and Bluetooth services.
Figure 22: iOS Services Enablement
Table 22: iOS Services Enablement Items
Item Description
1 Connection Issues: the application requires Bluetooth and WiFi to connect to the
camera
2 Open Settings
3 You turned off connection settings outside of the app
4 Connection Issue: app requires Bluetooth and WiFi
5 Open Settings and turn on Bluetooth and WiFi
6 Let's Get Started: press the highlighted buttons at the same time on the camera and
hold for 5 seconds to connect to the app
7 Press the Connect button
MN009878A01-B
Chapter 5 : SmartControl for Mobile
75
To Next Page
Loading...
Need help?
General
