EasyManua.ls Logo

Motorola solutions V700 - LTE Automatic Uploads

Motorola solutions V700
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Indicator Description
automatic upload and cancels the manual up-
load, and you cannot begin a new upload until
your 4G reception is higher than 59%.
6.2
LTE Automatic Uploads
Agencies can configure V700 cameras to automatically upload events over LTE to the agency
evidence management system as soon as they are recorded and tagged without docking the camera.
NOTE: The power source of V700 is a removable battery that is easy to replace to allow
continuous operation with minimal disruption. If the V700 battery level drops below 10%, the
automatic upload is paused until the battery is charged to at least 10% or more or another
charged battery is attached.
NOTE: If the LTE signal is below 50%, the LTE upload will suspend automatic uploads and
cancel manual uploads. When the LTE signal reaches above 50% again, automatic upload will
resume. Manual upload must be resumed manually through the menu. See
The following upload configurations are supported:
Table 24: Event Upload Configurations
Item Description
Upload All Events When configured, all critical and regular events are uploaded.
Upload Critical Events Only When configured, only critical events are uploaded. All other
events remain on the camera until docked.
6.2.1
Uploading Events Automatically over LTE
Prerequisites: For V700 to automatically upload, undock from the WiFi Base, the camera must have
an active connection to an LTE service and the agency evidence management system. If there is no
connectivity, the event automatically uploads as soon as there is a connection to both LTE and the
agency evidence management system. Check if the icon appears on the display to verify the
connection.
Procedure:
1 Start a recording on V700 by following the procedure in Starting a Recorded Event Manually on
page 31.
2 When you are finished, stop the recording by following the procedure in Stopping a Recorded
Event Manually on page 32.
NOTE: Uploading stops if you press the Record Start/Stop button and start a new
recording. After you stop and tag the new event, the camera begins the uploading
process again.
3 Tag the event by following the procedure in Categorizing a Recorded Event on page 32.
NOTE: If you do not tag the event in time, the event uploads with an uncategorized tag.
The following results occur:
MN009878A01-B
Chapter 6 : LTE Wireless Service
87

Table of Contents

Related product manuals