• Network preferences
• Officer preferences for indicators
• Recording group interaction
• Recording preferences
• Power and storage-saving preferences
• Event tags
For more information, see your agency evidence management system documentation.
3.3
V700 Display
The display on the V700 shows icons and messages to indicate the status of the camera. If a message
is longer than the screen width, the message scrolls. The display is on the top of the camera.
You can do and see the following on the display:
• The Home screen
When the camera is not recording an event, the default message shown on the display is the
storage status for the SD card and battery. For more information, see Home Screen on page 56.
Figure 11: Home Screen
• A default message shows on the display when the camera is in Covert Mode and not recording, and
is the inverse of what was on the normal screen
• Shows the SD card storage icon and the percentage of battery remaining
The V700 battery charge lasts up to 12 hours, depending on your configuration. When recording in
HD format, V700 can store about 36 hours of maximum-resolution events or up to about 200 hours
at low resolution
Figure 12: SD Card and Battery
• A blinking circle in the center that indicates the V700 is recording
• You can cycle through the Info Sequence by pressing the Display Backlight button
• You can cycle through the Menu by pressing the Function button
• You can cycle through the Info Sequence, which takes you back to the starting screen, by pressing
the Function button
MN009878A01-B
Chapter 3 : V700 Overview
54
To Next Page
Loading...
