Figure 16: Camera and Battery Storage
Table 11: Camera and Battery Storage Items
Item Description
1 The storage percentage used of the SD card.
2 The remaining battery storage percentage.
Low Storage and Full Storage Messages
When the camera is about 10 minutes away from running out of storage space, it alerts you with the
following:
• Two short tones and/or a vibration, depending on your alert configuration settings.
• Slow-blinking red LED and the storage used icon on the display.
When the camera storage is full, it alerts you with an error condition alert, such as the following:
• Fast-blinking red LED on the camera.
• Three short tones and/or a vibration, depending on your alert configuration settings.
• A FULL message on the display.
WARNING: If storage completely fills, the camera stops recording the new video.
3.12
GPS
The V700 includes a built-in Global Positioning System (GPS).
V700 uses the GPS feature to apply the following:
NOTE: You can also track GPS through LTE. For more information, see Location over LTE.
• Accurate timestamps to recorded events.
These timestamps allow the agency evidence management system to synchronize playback
between events, video or audio, from V700 and a 4RE or M500 DVR.
• GPS location coordinates to the V700 recorded events.
The fixed status, longitude, latitude, speed, and time of day information is sent to the metadata service
each second to be included in the event data. The speed information is compared to the configured
maximum speed to determine if the vehicle has exceeded the excessive speed trigger. If it has, a
message is sent to the event service to determine if an event should be started.
NOTE: The GPS feature can be disabled in your agency evidence management system
configuration.
MN009878A01-B
Chapter 3 : V700 Overview
63
To Next Page
Loading...
