Docking the V700 in the USB Base enables the following actions:
• Retrieves battery charging status
USB upload requires you to check out the V700 from a Transfer Station II to provision it with the
agency; this enables you to upload from the USB Base in the field.
2.15.1
Upgrading the V700 Firmware
You can push new firmware upgrades to the V700 while it is docked in the Transfer Station II, WiFi
Base, or USB Base, depending on your configuration.
Procedure:
1 Dock the camera in a WiFi Base, USB Base, or Transfer Station II with access to your agency
evidence management system.
If an upgrade is needed, your agency evidence management system automatically notices and
pushes the upgrade.
NOTE: V700 checks your agency evidence management system every 30 minutes for
firmware upgrades.
2 Keep the camera docked while upgrading.
WARNING: Do not remove the camera from the dock while its new firmware is being
applied. Removing the camera from the dock during the upgrade can cause the camera
to malfunction. The camera cannot perform any other function while upgrading its
firmware, including uploading a video.
While the upgrade is being staged on the camera, the display shows DO NOT INTERRUPT under the
upgrade bar, including Do not undock or Do not disturb above the bar.
When the upgrade is finished applying, depending on your alert notification selections, the camera
sounds the ready alert. You can safely undock the camera.
MN009878A01-B
Chapter 2 : V700 During a Shift
51
To Next Page
Loading...
