End of a Shift
• V700 Docking Overview on page 47
• USB Dock and Upload on page 50
• Powering Off on page 19
2.1
Power On and Off
To power the V700 on and off, you must use the Power button. The Power button is the oval shape on
the bottom of the V700 battery.
Figure 1: V700 Power On and Off Button
2.1.1
Powering On
Procedure:
On the bottom of the camera battery, press and release the Power button.
The camera goes through the booting and information sequences. When it is ready to use, the display
shows the number of events in storage and displays a solid green LED light on the top. Depending on
your agency configuration, the camera vibrates or plays an ascending tone sound.
2.1.2
Powering Off
Procedure:
1 On the bottom of the camera, press and release the Power button.
2 After the prompt, press the Power button again.
After you press the Power button the second time, the screen shows SHUTTING DOWN, and the green
LED turns off. Depending on your configuration, descending tones sound.
2.1.3
Forcing Power Off
WARNING: Avoid forcing the V700 to power off by abruptly removing the battery without going
through the shut down procedure above. Forcing the camera to power off can result in data
corruption.
MN009878A01-B
Chapter 2 : V700 During a Shift
19
To Next Page
Loading...
