2.3
Replacing the V700 Battery
The power source of the V700 is a removable battery that is easy to replace and allows continuous
operation with minimal disruption. You can remove the V700 battery and charge it separately from the
camera.
NOTICE: A charged spare battery ensures that you always have a source of power ready to
use without requiring the camera to remain in a charging dock or transfer station while the
battery is charging.
Figure 8: Replacing the V700 Battery
Procedure:
1 Power off the camera (Powering Off on page 19).
2 Slide the silver latch on the back of the camera to the left.
3 Pull straight down on the battery. Do not lift out.
4 To replace the battery, slide it into the tracks and push it in until it clicks.
2.4
Battery Charge
A full charge in the Transfer Station or WiFi Base can take up to six hours. The battery life depends on
the device configuration and LTE service.
Dock the camera with the battery or just the standalone battery in the WiFi Base, USB Base, or
Transfer Station II.
NOTE: Before using the camera for the first time, fully charge the battery and configure the
camera.
Motorola Solutions recommends using the V700 USB Base plugged into an outlet or the transfer
station inside your agency when fully charging the battery.
MN009878A01-B
Chapter 2 : V700 During a Shift
29
To Next Page
Loading...
