3 Press the Display Backlight button to navigate through the menu to Firearm.
4 Press the Function button to select a Firearm when the Firearm screen appears.
The camera starts searching for nearby sensors, showing a list of sensors.
NOTE: Connectivity issues can occur if you are in an area with a lot of wireless noise.
Move away from that area and try to connect again if you are having trouble connecting.
5 Press the Display Backlight button to cycle through the sensor serial numbers.
6 Press the Function button to select the sensor serial number of the sensor you want to pair
with.
The camera and sensor are paired when the Connected screen appears.
You can check the connection status in the Info Sequence. The Holster icon means that you
are paired.
7 Disconnect the sensor from the power supply.
NOTE: When connected to a power supply, the sensor remains in pairing mode for
one minute. After one minute, the sensor must be disconnected and reconnected to the
power supply re-enabling pairing mode.
2.13.2
Holster Aware Status
From the V700 menu for the firearm sensor, you can put the sensor into Safety Mode, which allows
you to remove the firearm from the holster and not start a recording.
Procedure:
1 Navigate to the Main Menu screen.
2 Press the Display Backlight button to search for sensors.
3 Press the Function button to enter the Sensor submenu.
4 Press the Display Backlight button to cycle to Safety Mode.
5 Press the Function button to put Holster Aware in Safety Mode On/Off.
The V700 notifies you when the sensor battery level is low or critical. The notification repeats for every
one percent drop in battery level until it reaches critical. The notifications remain on the screen for four
seconds. When the camera reaches the critical battery level, the notification for it remains until you
MN009878A01-B
Chapter 2 : V700 During a Shift
46
To Next Page
Loading...
