3.6.1.5
Cleaning the Battery and Camera
Follow this procedure on cleaning the battery and camera contact surfaces.
Procedure:
1 Remove the battery from the camera.
2 Clean the battery and camera contacts with a fine tipped cotton swab and isopropyl alcohol
(rubbing alcohol) with at least a 70% alcohol concentration.
NOTE: Never apply the alcohol directly to the battery or camera contacts in an
uncontrolled manner.
3 Gently clean all of the contact surfaces to remove debris with the fine tipped cotton swab.
IMPORTANT: Do not use bleach, solvents, or cleaning sprays to clean or disinfect your
battery and camera contacts.
3.6.1.6
Repairing the Battery or Camera
Process:
1 If cleaning the battery and camera contacts does not lead to full functionality, isolate the source
by changing the battery with a working one.
2 If replacing the battery resolves the issue, re-clean the battery and camera contacts.
3 If re-cleaning does not resolve the issue, contact customer service to replace the battery at
1-800-605-6734.
4 If replacing the battery does not resolve the issue, re-clean the camera contacts.
5 If re-cleaning does not resolve the issue, contact customer service to replace the camera at
1-800-605-6734.
See the Motorola Solutions Technical Notification (MTN), MTN-0134-20-NA issued 09/2020 at
https://www.motorolasolutions.com/en_us/support/technical-notifications.html.
3.7
Feedback Indicators
Apart from the display, the V700 can provide feedback on the status using the following:
• Tones
• Vibration
• Red and green LEDs
• Vibration only
• Tone and vibration together
• No tone or vibration
All of the feedback indicators are configurable in the agency evidence management system. You can
set up the tones and vibration to alert with the following:
• Tone only
• Tone and vibration together
• No tone or vibration
MN009878A01-B
Chapter 3 : V700 Overview
60
To Next Page
Loading...
