2.7.4.3
Covert Mode Alert
When the V700 is entering or exiting Covert Mode and an error condition occurs, the camera alerts you
by vibrating or playing tones.
The following scenarios can occur:
• The vibration and tones stop if you do not acknowledge the error and go into Covert Mode. The
exception is that the camera continues to vibrate or tones sound if the alert is a critical alert for
evidence capture
• When Covert Mode ends, the camera starts to vibrate or play tones because the error was not
acknowledged. After the alert is acknowledged, the vibration and tones stop
• If you acknowledge the error before accessing Covert Mode, the camera goes into Covert Mode.
When you exit Covert Mode, no notifications are presented
2.7.5
Bookmark/Snapshot
If enabled by your administrator, you can create a bookmark and/or snapshot while the V700 is
recording an event.
Creating a bookmark allows you to save a specific moment during a recorded event, and creating a
snapshot allows you to create and save an image of a specific moment during a recorded event.
NOTE: Your administrator must enable either or both features in your agency evidence
management system.
Press and release the Function button to create a bookmark or snapshot during a recorded event.
Depending on your agency configuration, one of the following screens will appear on your V700:
Table 5: Bookmark/Snapshot Screens
Icon Description
Bookmark only
Snapshot only
Both Bookmark and Snapshot
MN009878A01-B
Chapter 2 : V700 During a Shift
34
To Next Page
Loading...
