EasyManua.ls Logo

Motorola solutions V700 - Wifi Base Firmware Upgrade; Upgrading Wifi Base; Table 18: Network Activity LED

Motorola solutions V700
88 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
The left LED on the WiFi Base blinks green when it successfully pairs with a V700. The LED blinks red
if the pairing was not successful.
NOTE: If you get a solid red light, try undocking and redocking your camera and battery. If solid
red appears repeatably, you should contact customer service.
Table 18: Network Activity LED
LED state State WiFi Base state
Off Connected to the Distributed Multi-Peer Re-
cording upload server (agency evidence man-
agement system)
Amber Solid Not connected to the camera or upload server
(agency evidence management system)
Amber Blinking Activity with the upload server (agency evi-
dence management system)
Green Solid Connected to the camera (Wi-Fi connection)
Green Blinking Activity with the camera (Wi-Fi connection)
If two cameras pair with the same WiFi Base, and one is docked, the WiFi Base LEDs show the state
of the docked camera.
3.13.3
WiFi Base Firmware Upgrade
The V700 Camera automatically pulls firmware upgrades for the WiFi base from your agency evidence
management system when the V700 is docked in a Transfer Station II.
NOTE: Your agency evidence management system can be set up to push new firmware
automatically. For instructions, see your agency evidence management system documentation.
The camera checks every 30 minutes if a new firmware upgrade is available.
3.13.3.1
Upgrading WiFi Base
Procedure:
1 Dock the V700 in the Transfer Station II.
2 Upload events.
a If an upgrade is available, your agency evidence management system pushes the firmware
upgrade after the video upload completes.
3 Remove the V700 and dock it in the WiFi Base. The base upgrade occurs automatically.
a The amber LED blinks quickly.
b When the upgrade is complete the amber LED blinks slowly.
4 Power cycle the in-car system so that the upgrade will take effect immediately.
NOTE: If you undock the camera before the upgrade is complete, the camera downloads
the upgrade the next time the camera is docked. The upgrade does not take effect until
the download is complete and the in-car system powers up.
MN009878A01-B
Chapter 3 : V700 Overview
68

Table of Contents

Related product manuals