6 Clip the mount to your jacket.
7 Press the silver bar on top to release the camera.
2.2.5
Mounting the Heavy Jacket Magnetic Mount
The Heavy Jacket Magnetic Mount provides an option to wear the camera on heavier materials, such
as a jacket or other outerwear.
When and where to use:
Figure 6: Heavy Jacket Magnetic Mount
Procedure:
1 Perform the following actions to separate the under-shirt bracket from the over-shirt bracket:
a Hold the under-shirt bracket in one hand with the thumb on top and the two middle fingers on
the bottom.
b Raise the levers on both sides.
c While holding the levers up, pull the brackets apart.
2 Match the anchor tabs and camera slots on the over-shirt bracket with the back of the camera—
keeping the magnets apart.
NOTE: You can attach the camera before or after the mount is in place.
3 Place the under-shirt bracket under your shirt where you want to wear your camera.
4 Line up the anchor slots and place the over-shirt against the under-shirt bracket, with your shirt
between them.
The anchor slots snap together forcefully.
CAUTION: WATCH YOUR FINGERS! Because of the strength of the magnets,
separating the brackets requires some effort. Realigning the brackets causes them to
snap together forcefully. Keep your hand flat and keep your fingers away from the
snap-to area.
MN009878A01-B
Chapter 2 : V700 During a Shift
27
To Next Page
Loading...
