Motorola solutions V700 - Mounting the Belt;Strap Mount; Figure 7: Belt;Strap Mount

2.2.6
Mounting the Belt/Strap Mount
The Belt/Strap Mount gives you the option to mount the camera to a belt or strap on your uniform.
Prerequisites: Install the mount before you connect the camera to the mount.
Figure 7: Belt/Strap Mount
Procedure:
1 Determine the belt or strap you want to mount the camera to.
NOTE: The TEK-LOK
™
attachments can be adjusted to fit the width of your belt/strap
width.
2 On the top of the TEK-LOK attachment, throw over the secondary lock tab.
3 Press both release tabs toward each other and open the TEK-LOK attachment.
4 Place the TEK-LOK attachment over the top of your belt.
5 Press and squeeze the TEK-LOK attachment closed.
NOTE: The TEK-LOK will click into place when it is secure.
6 Throw over the secondary lock tab.
7 Align the camera with the two tabs on the bottom of the mount and snap the camera in to the
mount.
8 To remove the camera, press the silver bar and pull straight up on the camera and battery.
9 Remove the camera and battery.
MN009878A01-B
Chapter 2 : V700 During a Shift
28