68P80801E30-A 5/1/2002 8-5
Gen 3 Site Controller System Manual Chapter 8 Software Commands
Site Controller Commands
VER
Syntax:
ver
The 'ver' command prints the Install/Test application software version.
Example:
QUIT
Syntax:
quit
The 'quit' command resets the site controller to exit the Install/Test
application.
Example:
DISPLAY EAS
Syntax:
display eas
The 'display eas' command lists the status of all the EAS/EAS2 contacts. A
sample of the output is shown.
iSC> ver
iSC3 Factory Install R09.02.02-ACG-INSTALL
iSC> quit
Do you really want to quit? [n]
Answer 'y' at the prompt to reset the board.
To Next Page
Loading...
