Chapter 8 Software Commands Gen 3 Site Controller System Manual
Site Controller Commands
8-6 68P80801E30-A 5/1/2002
Example:
DISPLAY GPS ALARMS
Syntax:
display gps alarms
The 'display gps alarms' command lists alarm conditions preset in the CPS
Receiver.
Example:
PING GPS
Syntax:
ping gps
iSC> display eas
CODE DESCRIPTION
201 50 Pin Telco B: pin 11 alarm
202 50 Pin Telco B: pin 9 alarm
203 50 Pin Telco B: pin 27 alarm
204 50 Pin Telco B: pin 25 alarm
iSC>display gps alarms
GPS Alarm StatusOK
Self-test OK
GPS Software version OK
GPS Communications OK
Online Fault OK
Idle-mode fault OK
GPS 1PPS OK
HSO 1PPS OK
HSO locked to GPS UNKNOWN
Time/frequency output #1 OK
Time/frequency output #2 OK
Oscillator aging UNKNOWN
Total number of alarms 0
To Next Page
Loading...
