68P80801E30-A 5/1/2002 8-7
Gen 3 Site Controller System Manual Chapter 8 Software Commands
Site Controller Commands
The 'ping gps' command lists the operation status of the CPS.
Example:
STATUS GPS
Syntax:
status gps
The 'status gps' command lists the tracking status of any CPS satellites that
the site controller is tracking.
Example:
iSC> ping gps
GPS on line
Satellite Tracking Status site sync down
Frequency Lock Status notlocked.
Alarm status OK
iSC>status gps
0 satellites tracked (4 are required)
ID Mode S/N
900
3000
1900
200
2200
2000
2500
2700
Latitude N 0 deg 0 min 0.000 sec
Longitude E 0 deg 0 min 0.000 sec
Altitude 59.0 feet below sea level
Date/Time 01/01/1999 12:26:03 GMT