Motorola iDEN Site Controller User Manual

Chapter 8 Software Commands Gen 3 Site Controller System Manual
Site Controller Commands
8-8 68P80801E30-A 5/1/2002
DISPLAY TEMP
Syntax:
display temp
The command 'display temp' displays the temperature of the site controller
in degrees Centigrade.
Example:
PING STANDBY
Syntax:
ping standby
The 'ping standby' command sends a ping message to the standby site
controller. If the standby site controller is alive, it returns a ping response.
This response contains information about its availability.
Example:
SWITCH ISC
Syntax:
switch isc
The 'switch isc' command forces the standby site controller to become the
active site controller, and the active site controller to become the standby site
controller. This command cannot be executed on the standby site controller.
The standby site controller must be up and running the site controller Install/
Test application.
iSC> display temp
GPS Temperature OK at 34 deg C
iSC> ping standby
Standby iSC is available
Standby GPS is not available

Motorola iDEN Site Controller Specifications

General

Brand	Motorola
Model	iDEN Site Controller
Category	Controller
Language	English