68P80801E30-A 5/1/2002
iii
Gen 3 Site Controller System Manual Front Matter
Contents
Chapter 6 System Testing 6-1
Chapter Overview ............................................................................... 6-1
Testing Overview............................................................................................... 6-2
MMI commands ................................................................................. 6-2
Test procedures ................................................................................... 6-2
Site Controller Verification ...............................................................................6-3
Site Controller Test Equipment ......................................................... 6-4
Service Computer Startup ................................................................. 6-4
Site Controller Startup Sequence ...................................................... 6-5
E1/T1 Configuration ........................................................................... 6-7
ACG# help ........................................................................................6-9
Loading the Base Radios ................................................................................. 6-12
Standby Site Controller Status.........................................................................6-14
Base Radio Registration ..................................................................................6-15
T1 Connection Test.......................................................................................... 6-17
Remotely Looping Back the T1 Site Controller for BER Testing................... 6-20
Two Types of T1 Loop-Back ............................................................ 6-20
Three Different Ways to Start and Stop a
T1 Line Loop-Back on the Site Controller ............................... 6-21
How Payload Loop-Back Works on the Site Controller ................... 6-21
Starting and Stopping Loop-Backs ..................................................6-22
Remotely Looping Back the E1 Site Controller for BER Testing................... 6-23
Two Different Ways to Start and Stop a
E1 Line Loop-Back on the Site Controller ............................... 6-23
Front Panel Line Loop-Back Switch ................................................ 6-24
EAS/EAS2 Alarm Checkout............................................................................ 6-25
GPS Status ....................................................................................................... 6-29
Site Reference.................................................................................................. 6-31
Chapter 7 System Troubleshooting 7-1
Chapter Overview ............................................................................... 7-1
Troubleshooting................................................................................................. 7-2
Controller........................................................................................................... 7-3
EAS/EAS2 Unit ...............................................................................................7-6
Chapter 8 Software Commands 8-1
Chapter Overview ............................................................................... 8-1
MMI Commands................................................................................................ 8-2
Access Level ....................................................................................... 8-2
Conventions ........................................................................................8-2
Site Controller Commands ................................................................................8-4