68P80801E30-A 5/1/2002 3-31
Gen 3 Site Controller System Manual Chapter 3 Pre-Installation
Recommended Tools, Equipment, and Parts
knife, utility n/a locally procured n/a
markers (2) n/a locally procured n/a
nut driver, 3/16” n/a locally procured n/a
nut driver, 10
mm
n/a locally procured n/a
pliers n/a locally procured n/a
pliers, connector n/a Snap-on n/a
pliers, needle
nose
n/a locally procured n/a
screw driver,
torque hand tool
5 in-lbs Ind Pneumatic n/a
drives for torque
screw driver
1/4” drive, 7/16”
deep socket
Ind Pneumatic n/a
1/4” drive, 5/16”
deep socket
n/a
1/4” drive, 3/16”
socket
n/a
1/4” drive, 1”
blade
screwdriver
n/a
1/4” hex to 1/4”
hex drive
n/a
screw drivers #0 Phillips locally procured n/a
#2 Phillips n/a
3/16” blade n/a
#1 blade n/a
1/4” blade n/a
step ladder 7’ locally procured to gain access to
cable tray
assembly
tarpaulin approximately
8’ x 10’
locally procured protect equipment
during installation
Table 3-8 Recommended tools for installation — continued
Tool Model/type Supplier Purpose
To Next Page
Loading...
