Restarting the System
http://www.motorola.com/computer/literature 2-3
2
Restarting the System
You can initialize the system to a known state in two different ways: reset
or break. Each method has characteristics that make it more appropriate
than the other in certain situations.
Reset
Powering up the MBX Series board initiates a system reset. Resets can also
be asserted through the Reset switch, available remotely via utility
connector #1 (J16 on the MBX board). Both “cold” and “warm” reset
modes are available. By default, EPPCBug is in “cold” mode (refer to the
Reset command description in the EPPCBug Firmware Package User’s
Manual).
2156 9802
STARTUP
SYSTEM
INITIALIZATION
CONSOLE
DETECTION
STARTUP SCRIPT
EXECUTION
(IF ENABLED)
OPERATING
SYSTEM
To Next Page
Loading...
Need help?
General
