Installing Expansion Modules
http://www.motorola.com/computer/literature 1-7
1
Configure the terminal for 9600 baud, eight bits per character, one stop
bit per character, and no parity.
Notes 1. 9600 baud is the default baud rate of MBX ports at
power up. After power up you can, if you wish,
reconfigure the serial ports by programming the MBX
console interface, or by using the EPPCBug Port Format
( PF) command.
2. In order for high-baud-rate serial communication
between EPPCBug and the terminal to work, the
terminal must do some form of handshaking. If your
terminal does not do hardware handshaking via the CTS
line, then it must do XON/XOFF handshaking. If you get
unintelligible messages and missing characters, check
the terminal to be sure that XON/XOFF handshaking is
enabled.
9. Replace the chassis or system cover(s), reconnect the system to the AC
or DC power source.
10. Proceed to Chapter 2, Startup and Operation.
Installing Expansion Modules
PC/104 (ISA), PC/104-Plus (PCI), 8xx/COMM, and PCMCIA expansion
modules plug into the top of the MBX board. In most cases, it will be more
convenient to add expansion modules to the MBX board before it is
installed in a system chassis. However, you can attach modules even if the
MBX is already installed, so long as the board is accessible.
To install an expansion module, refer to Figure 6-1 on page 6-2 for the
location of the appropriate connectors and jumper headers and follow the
steps below.
No tools are necessary for this procedure, except those needed to remove
chassis or system cover(s).
Notes 1. If you add an 8xx/COMM expansion module (user-supplied),
it must be installed first; PC/104 and PC/104-Plus modules
To Next Page
Loading...
Need help?
General
