Using Bluetooth 3 - 27
Figure 3-38
Send Local Picture Window
4. Navigate to the picture to send to the other device.
5. Tap Open.
6. Tap OK to send the picture to the other device and display a confirmation dialog box on the other device to
accept the picture. A Send Picture dialog appears.
7. Tap Ok.
Headset Services
To connect to a Bluetooth headset:
1. Ensure the MC31XX is connectable (required when automatic re-connect is initiated). See Device Info Tab on
page 3-33.
2. Ensure that the Headset profile is enabled on the MC31XX. See Profiles Tab on page 3-42 for more
information.
3. Use the Connection Wizard to search for a Bluetooth headset.
4. Select the device and tap Next.
5. Select the Headset service name and select Connect. The MC31XX connects to the headset. Refer to the
headset user manual for instructions on communicating with a Bluetooth device.
6. Press the communication button on the headset. This routes both system and voice call audio to the headset.
7. When a call is received on the MC31XX, tap the Accept button to answer the call.
8. Press the communication button on the headset to route the audio back to the MC31XX.
Serial Port Services
Use the wireless Bluetooth serial port connection as you would a physical serial cable connection. Configure the
application that will use the connection to the correct serial port.
NOTE Newer Bluetooth headsets are device dependant and remember the last device they connected to. If problems
occur while connecting to the headset, place the headset in discovery mode. Refer to the headset user manual
for more information.
NOTE When using a Bluetooth headset with Headset Services, you cannot accept or end a call from the headset.
You must accept or end a call on the MC31XX.
To Next Page
Loading...
Need help?
General