MOTOTRBO
TM
MTR3000 Base Station/Repeater
Supplemental Safety and Installation Requirements
ATTENTION!
The MOTOTRBO MTR3000 Base Station/Repeater must be installed in a suitable, in-
building enclosure. A restricted access location is required when installing this equipment
into the end system.
The base station/repeater contains a Class 1 built-in power supply component. It is
equipped with an appliance inlet for connecting to an AC input, as well as DC input
terminals which meet SELV DC circuit requirements.
When installing the equipment, all requirements of relevant standards and local electrical
codes must be fulfilled.
The maximum operating ambient temperature of this equipment is 60°C. The maximum
operating altitude is 3000 meters above sea level.
The 28.6 VDC output from the power supply to the PA is at an energy hazard level
(exceeds 240 VA). When installing into the end system, care must be taken so as not to
touch the output wires.
When the MOTOTRBO MTR3000 Base Station/Repeater is used in a DC reverting system,
the DC power supply must be located in the same building as the MOTOTRBO MTR3000
Base Station/Repeater, and it must meet the requirements of a SELV circuit.
To Next Page
Loading...
Need help?
General
