19.6
Setting Audio
Procedure:
1 From the home screen, press the Menu key.
2 Select Setup→Audio.
3 Set audio by using the following options:
Option Actions
Adjusting audio parameters in
the current operating environ-
ment
a Select Audio Profile.
b Select a required profile.
Setting the howling suppres-
sion mode
a Select Howling Suppr..
b Select the required setting.
NOTE: Howling suppression increases the
stability of the acoustic feedback loop. Your
service provider can set up the state of the
howling suppression on powering up the ra-
dio. Depending on the settings, the radio can
either disable the howling suppression or set
the last remembered state.
Setting the noise suppression
mode
a Select Noise Suppr..
b Select one of the following options:
• Disabled - Disable noise suppression.
• Basic - Enable basic noise suppression.
• Advanced
1
- Enable dual microphone noise sup-
pression.
• Wind Suppr.
1
- Enable dual microphone noise
suppression with wind suppression capability.
Controlling audio routing be-
tween the speaker and ear-
piece for private or group call
a Select Audio Toggle.
b Select one of the following options:
• Always Loud - For high audio to come from the
speaker.
• Spkr Cntrl - For audio to go through the ear-
piece or speaker.
Setting the volume to Individu-
al or Common
a Select Volume Adj. Mode.
b Select Individual or Common.
Setting extra loud volume on
accessories
a Select Extra Loud Accry.
1
Option is only available when the Software Selling Feature Dual Microphone Noise Suppres-
sion is enabled.
MN006360A01-AE
Chapter 19: Setup
112
To Next Page
Loading...
