EasyManua.ls Logo

Motorola MXP600 - LED Status Indication; Table 11: LED Status Indication

Motorola MXP600
164 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
6.2
LED Status Indication
Table 11: LED Status Indication
Indication Status when Not Charging Status when Charging
Solid green
In use
Repeating call
Battery is fully charged
Blinking green
In TMO service or idle
Switching modes from TMO to
DMO
Battery is charged at 90%
Solid red Out of service Rapid charge
Blinking red
Connecting to a network
Switching modes from DMO to
TMO
Faulty or invalid battery
Solid orange
Radio is powering on
Transmit inhibit mode in service
Channel busy in DMO
Radio interference in DMO
Not applicable
Blinking orange Incoming private or phone call Battery is on standby to rapid charge
No indication
Radio powered off
Radio in Covert Mode
Not applicable
NOTE:
When you charge your radio in a multi-unit charger and the battery is at the 90–100% charge
level, the LED indicators on your radio and on the multi-unit charger differs:
LED on your radio – blinking green.
LED on the multi-unit charger – solid green.
If you insert your radio with a deeply discharged battery into the multi-unit charger, the LED on
your radio shows blinking red, indicating a charging error. Resolve this error by reinserting your
radio.
MN006360A01-AE
Chapter 6: Status Indications
50

Table of Contents

Other manuals for Motorola MXP600

Related product manuals