Motorola MXP600 - Connecting Devices; Disconnecting Devices; Managing Devices

20.6
Connecting Devices
NOTE: If Secure Connection Only is enabled for your radio, your radio only connects to
accessories that support secure connection. Your radio can only pair with one device using
secure connection.
Prerequisites:
• To connect to specific devices, contact your service provider to configure your radio.
• Use only pre-approved sensor devices such as barcode scanners and heart rate sensors.
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Devices.
3 Highlight the required device and press Menu/OK.
NOTE:
Depending on languages installed on the radio, some characters in names of devices
might not be displayed properly.
Radio-initiated automatic reconnection with several remote Bluetooth devices at the
same time cannot be guaranteed to be successful in 100%, due to the fundamental
nature of Bluetooth. In case the reconnection fails after a power cycle, reconnect the
device manually.
4 Select Connect.
20.7
Disconnecting Devices
Procedure:
1 From the home screen, press the Menu key.
2 Disconnect devices from your radio by using one of the following options.
Option Actions
Disconnecting a de-
vice
a Select Bluetooth→Devices.
b Highlight the required device and press Disconnect.
Disconnecting all de-
vices
Select Bluetooth→Disconnect All.
20.8
Managing Devices
Procedure:
1 From the home screen, press the Menu key.
2 Select Bluetooth→Devices.
3 Highlight the required device and press the Menu key.
MN006360A01-AE
Chapter 20: Bluetooth
125