Motorola MXP600 - Chapter 22: Group Setup; Operation Parameters; Determining Radio Mode at Radio Startup; Determining Talkgroup at Radio Startup

Chapter 22
Group Setup
The Group Setup menu item allows you to set the operation parameters, scanning and my groups
folder.
22.1
Operation Parameters
Operation Parameter is used to define the radio mode and the talkgroup at the radio startup, and when
changing modes TMO to DMO and TMO to Repeater.
22.1.1
Determining Radio Mode At Radio Startup
When and where to use:To set radio mode at startup.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Operations Parameters→Startup.
3 Select one of the following options:
Option Desciption
TMO Your radio powers up in Trunked Mode Operation
(TMO).
DMO Your radio powers up in Direct Mode Operation
(DMO).
Last Selected Your radio powers up in the mode it was in when
last powered down.
22.1.2
Determining Talkgroup At Radio Startup
When and where to use:To determine the talkgroup of your radio at radio startup.
Procedure:
1 From the home screen, press the Menu key.
2 Select Group Setup→Operations Parameters→Home Group Startup.
3 Select one of the following options:
Option Desciption
Last Selected Your radio enters the last selected TMO or DMO
talkgroup before power down.
Home Group Your radio enters the Home Group (TMO or DMO)
at power-up, depending on the radio mode entered
at power up.
MN006360A01-AE
Chapter 22: Group Setup
132