NE-4100 Series User’s Manual Serial Command Mode
9-10
When the trigger has been configured, click OK to save and restart the module with the new
settings.
ATTENTION
The default setting is HW Trigger Enabled. Only one type of trigger may be selected; hardware
and software trigger may not be used at the same time.
Select Activated b
Character to
trigger serial command mode through
the serial port. In this case, you will also
need to enter the three characters (in
HEX code) that will be used as the
trigger characters.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-9766-Moxa-NE-4120A.aspx
To Next Page
Loading...