9
9
Chapter 9 Serial Command Mode
Serial command mode allows configuration of the module through serial commands received
directly through the serial port. It is available on NE-4100 Series modules with firmware version
3.0 and above
This chapter includes the following sections:
Overview
Serial Command Format and Command Set
¾ Command Structure
¾ Reply Structure
¾ OP Codes and Parameters
Operation Flow Chart
Configuring Trigger Type
¾ Network Enabler Administrator
¾ Telnet Console
¾ Web Console
¾ Serial Console
Entering Serial Command Mode
¾ Trigger Type
¾ Serial Port Parameters
¾ Comments
Exiting Serial Command Mode
Determining the Active Mode
Serial Command Examples
¾ Example 1: Get Model Name Using HW Trigger
¾ Example 2: Change IP Address Using HW Trigger
¾ Example 3: Get IP Mode Using SW Trigger
¾ Example 4: Change TCP Port Number Using SW Trigger
To Next Page
Loading...