NE-4100 Series User’s Manual Network Enabler Administrator
7-7
Unlock
Unlock is used to enter the password of locked modules in order to view and changes settings. In
the Configuration module list, the Status field shows the password status of the module, as
follows:
Status Description
Lock The module is password protected, Broadcast Search was used to locate it, and the
password has not yet been entered.
Unlock
The module is password protected, Broadcast Search was used to locate it, and the
password has been correctly entered. Henceforth during this Network Enabler
Administrator session, activating various utilities for this module will not require
re-entering the password.
Blank The module is not password protected, and Broadcast Search was used to locate it.
Fixed
The module is not password protected, and Specify by IP address was used to locate
it. Note that the term Fixed is borrowed from the standard fixed IP address networking
terminology.
Lock
Fixed
The module is password protected, Specify by IP address was used to locate it, and
the password has not yet been entered from within the current Network Enabler
Administrator session.
If the module is password protected, you will see the following message when you try to access
most functions.
You will need to unlock the module to make any modifications to the module’s configuration.
1. Select Unlock from the Configuration context menu. Note that this menu may also be
opened by right-clicking Configuration in the navigation panel, or by right-clicking the
selected module.
To Next Page
Loading...