NE-4100 Series User’s Manual Web Console Configuration
6-23
DIO Monitor
The DIO Monitor page polls and displays the mode and status of each DIO channel. You may use
this page to verify changes that were made in the DIO Settings page.
NOTE: “Serial Command Mode” is supported in firmware version 3.0 and above.
Serial Command Mode
Serial command mode is a special mode for configuring the module through the serial device itself.
It is supported in firmware version 3.0 and above. Please refer to Chapter 9 for information on
Serial Command Mode.
Change Password
Click on Change Password in the navigation panel to display the Change Password window.
NOTE: “Serial Command Mode” is supported in firmware version 3.0 and above.
Enter the old password and new passwords and click on Submit. To remove password protection,
leave the new password blank and just enter the old password.
ATTENTION
If you forget the password, the ONLY way to configure the module is to “load factory defaults.”
Remember to export the configuration file with Network Enabler Administrator after you have
finished configuring the module. Your configuration can then be imported back into the module
if you have to load the factory defaults. Please refer to Chapter 7 for more details about
importing and exporting the module’s configuration.
To Next Page
Loading...
Need help?
General