Moxa Technologies NE-4100 Series User Manual

NE-4100 Series User’s Manual Web Console Configuration
6-8
Auto report period
Setting Factory Default Necessity
Time interval (in seconds) 10 Optional
The Auto report period field specifies how often the module will report its IP address. An auto
report period of 10 seconds means that an IP address report will be sent every 10 seconds.
ATTENTION
The module will send IP address reports only when assigned an IP address from a DHCP or
BOOTP server. If a connection to a DHCP or BOOTP server is not available, no IP address
report will be sent.
Serial Settings
NOTE: “Serial Command Mode” is supported in firmware version 3.0 and above.
Port Alias
Setting Factory Default Necessity
1 to 15 characters (E.g., PLC-No.1) None Optional
This function is designed for future use. You may enter a string to help in the module’s serial port
from other serial ports.
Serial Parameters
ATTENTION
Refer to the serial communication parameters in your serial device’s user’s manual. The
module’s serial parameters should be the same as the parameters used by your serial device.
Baud Rate
Setting Factory Default Necessity
50 bps to 115.2 Kbps for PCB V1.x 110
bps to 230.4 Kbps for PCB V2.x
115.2 Kbps Required
The module can be set for baud rates between 50 bps and 115.2 Kbps for PCB V1.x and between
110 bps to 230.4 Kbps for PCB V2.x.
RSPSupply - 1-888-532-2706 - www.RSPSupply.com
http://www.RSPSupply.com/p-9766-Moxa-NE-4120A.aspx

Moxa Technologies NE-4100 Series Specifications

General

Brand	Moxa Technologies
Model	NE-4100 Series
Category	Control Unit
Language	English