NE-4100 Series User’s Manual Network Enabler Administrator
7-20
Apply and Discard Change
Apply Change and Discard Change are used to save or delete any changes COM mapping
settings. Select Apply Change in the COM Mapping context menu to save any changes made to
the COM mappings; select Discard Change to undo any changes that were made to the COM
mappings. Note that this menu may also be opened by right-clicking COM Mapping in the
navigation panel or by right-clicking the desired module.
Import and Export COM Mapping
Import COM Mapping and Export COM Mapping are used to save and load the COM
mappings for the Select Import COM Mapping in the COM Mapping context menu to load
settings into the selected module from an exported file; select Export COM mapping to save the
current settings for the selected module to a text file. Note that this menu may also be opened by
right-clicking COM Mapping in the navigation panel or by right-clicking the desired module.
IP Address Report Functions
IP Address Report functions are used to view IP address reports from appropriately configured
modules. When monitoring is activated, Network Enabler Administrator listens for IP address
reports on a UDP port number, which may be configured under Settings in the IP Address
Report context menu. Any IP address reports received at this port number will be displayed in the
window.
Select Go to begin monitoring for IP address reports, Stop to cease monitoring, and Clear to clear
the current display of reports.
Note that in order for a PC running Network Enabler Administrator to receive IP address reports
from a module, the module must set the PC’s IP address as the destination. In addition, the module
and the PC’s designated port number for IP address reports should match. Please refer to the
Network Settings section in Chapter 6 for additional information on configuring a module to send
IP address reports.
To Next Page
Loading...
Need help?
General